![]() And again for demonstration purposes we will not assign any of the alarms for any of the channels.Īt this point you have completed the Basic Configuration Setup of your 4 Channel nanodac data recorder and are ready to install into your control panel. Once again, clicking on the trend tab you can change the color of this channels pen to your desired color.Basically, setting the channel as type K thermocouple input, scaled 0-1372☌, with no decimal point resolution. Next you can click on folder 2, folder 3, and folder 4, making all of the same changes that you just did in folder #1.Again for this demonstration will we not assign or configure any Alarms for this input channel. Here you can change the color of pen representing this input channel on the faceplate of the nanodac. For this demonstration we will make all four input channels Type K Thermocouple inputs scaled 0-1372☌ with no decimal point display resolution. For this demonstration we will leave the descriptor at Channel 1. Starting from the top, change the Descriptor of this input channel to your desired description.Click on the MAIN tab if not already selected in the main iTools window.Now you’ll see all of the sub-subfolders within the 1 FOLDER listed vertically in this same window as well as listed horizontally across the main window of iTools. Next Double Click on the 1 Folder located on the left side of the iTools window. ![]() Now you’ll see all of the subfolders within the CHANNEL FOLDER listed vertically in this same window as well as listed horizontally across the main window of iTools. Double-click on the CHANNEL FOLDER located on the left side of the iTools window.Based on these values and the standard internal flash memory size of 50MB, you will see that the time until flash memory is full has been calculated at 250.96 days. For this demonstration leave the recording interval time at 10 seconds and the UHH file compression at NORMAL. Next ensure that Trend Point 1 thru 4 is set as Channel 1 through 4 respectively.For this demonstration we will leave the Trending value set at 10 Seconds. Click on the TRENDING tab and change the Trending Interval to your desired value.Now you’ll see all of the subfolders within the GROUP FOLDER listed vertically in this same window as well as listed horizontally across the main window of iTools. Double-click on the GROUP FOLDER located on the left side of the iTools window.Ensure that the current date and time is correct. Next if you want to setup DST Day Light Savings Time do so at this time by selecting YES and entering the proper data requested for day light savings time.At the date of this video tutorial we are at GMT-05:00. Next select the proper Time Zone for your area.For this demonstration will we choose month day year (MM/DD/YY). Click on the LOCALE tab in main window of iTools.Now you’ll see all of the subfolders within the INSTRUMENT FOLDER listed vertically in this same window as well as listed horizontally across the main window of iTools. Double-click on the INSTRUMENT FOLDER located on the left side of the iTools window.This symbol is telling you that you are now in the configuration setup level. Please note that a yellow colored symbol with a wrench in it will be displayed on the nanodac picture at the bottom left corner of the iTools display as well as next to the nanodac communications address near the top left of the iTools window. Next you will see another pop up window asking you for the configuration passphrase.Next you will see a popup warning window asking you to select yes or no at this point just select yes.First let’s begin by putting the nanodac controller into the configuration mode by clicking on the access icon at the top of the iTools window.Do not proceed until the synchronization has completed. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |